Go kart throttle hook up

go kart throttle hook up

How do you install a throttle cable on a go kart?

Cable Tab: Weld the throttle cable tab on about a 45 degree angle on the center beam of the kart. The tab should be spaced 4″ back from the center of the throttle pivot hole. When the cable is bolted to this bracket or tab, it should face where the eyelet will hook up to the pedal.

What is a go kart throttle pedal?

The go kart throttle pedal (also known as a gas pedal) is the one on the right of the picture with its associated return spring and hardware used to mount it to the go kart frame.

Where do you Mount the throttle cable?

The stock pivot arm has been cut on the side where the nut and bolt was originally located. We use the small hole on the opposite side of the pivot arm for the throttle rod and return spring. After the pivot arm is in place you can find a good location for the throttle cable mount.

How do I install a throttle kit?

Use needle nose pliers to hook the spring on the L shaped bracket and the tab on the throttle lever. Then twist the ends of the spring with the needle nose pliers to ensure the spring cannot come off. Your throttle kit is now installed. Check your throttle to make sure the return spring closes the throttle lever completely.

What parts do I need for a go kart throttle?

Go kart throttle setup instructions include the go kart throttle pedal, return spring, cable, and engine linkages. When installing a go kart throttle cable following the free go kart plans that I have on my site, I used the following throttle cable parts from the kit.

How do you install a throttle cable?

Install the throttle cable into the conduit retainer. The wire swivel stop fits nicely in the throttle lever. You dont need to remove the throttle plate. Hold the wire swivel stop in place with one hand while you thread the throttle cable into it with the other hand.

What is a go kart throttle pedal?

The go kart throttle pedal (also known as a gas pedal) is the one on the right of the picture with its associated return spring and hardware used to mount it to the go kart frame.

Can you sit on a go kart and drive?

Now that the go kart throttle cable and associated linkages are made, you are pretty much done with the go kart fabrication. You could sit on it and drive, but there are a few more extras you should consider fabricating to make the kart safer, or cooler, or both.

How much does a throttle kit cost?

Other throttle kits on the market can cost upwards of $150. The Vortex throttle is the fastest throttle available from Motion Pro and will open your throttle body to full throttle in just 45 degrees of twist (1/8 turn). This throttle kit is very responsive over the stock thumb assembly.

How does a throttle body assembly work?

Shown here is a traditional throttle body assembly found on older vehicles, with a cable thats manually linked to the accelerator pedal. A modern throttle body assembly contains an electronic sensor reading gas pedal input, and an electric motor to open the valve.

How do I install a twist throttle on my bike?

When the old thumb throttle housing is removed, you will need to remove the grip on the throttle side so you can install the twist throttle assembly onto the handlebars. Install the cable into the new housing as specified in the included instructions that came with your kit.

How does the throttle position sensor work on a car?

The throttle (gas pedal) position sensor relays this information to the vehicle’s main computer, the electronic control unit (ECU). The ECU takes that information and commands a small electric motor to open or close the throttle plate.

Related posts: